-
Ontario Provincial Standards
-
OPSD 2117.010 - Electrical Maintenance Holes General Installation Requirements
-
OPSD 704.010 - Maintenance Holes, Catch Basins and Valve Chambers, Precast Concrete Adjustment Units
-
OPSS.MUNI 407 - Maintenance Hole, Catch Basin, Ditch Inlet and Valve Chamber Installation
-
OPSS.MUNI 408 - Adjusting or Rebuilding Maintenance Holes, Catch Basins, Ditch Inlets, and Valve Chambers
-
OPSS.MUNI 602 - Installation of Electrical Chambers
-
OPSS.PROV 407 - Maintenance Hole, Catch Basin, Ditch Inlet and Valve Chamber Installation
-
OPSS.PROV 408 - Adjusting or Rebuilding Maintenance Holes, Catch Basins, Ditch Inlets, and Valve Chambers
-
OPSS.PROV 602 - Installation of Electrical Chambers
-
ASTM International
-
ASTM D1238-10 - Flow Rates of Thermoplastics by Extrusion Plastometer
-
ASTM D149-09(2013) - Dielectric Breakdown Voltage and Dielectric Strength of Solid Electrical Insulating
-
ASTM D1505-10 - Density of Plastics by the Density-Gradient Technique
-
ASTM D1525-09 - Vicat Softening Temperature of Plastics
-
ASTM D1531-06 - Relative Permittivity (Dielectric Constant) and Dissipation Factor by Fluid Displacement Procedures
-
ASTM D1693-12 - Environmental Stress-Cracking of Ethylene Plastics
-
ASTM D2240-05(2010) - Rubber Property-Durometer Hardness
-
ASTM D256-10 - Determining the Izod Pendulum Impact Resistance of Plastics
-
ASTM D570-98(2010)e1 - Water Absorption of Plastics
-
ASTM D638-14 - Tensile Properties of Plastics
-
ASTM D648-07 - Deflection Temperature of Plastics Under Flexural Load in the Edgewise Position
-
ASTM D668-99(2004) - Measuring Dimensions of Rigid Rods and Tubes Used for Electrical Insulation
-
ASTM D695-15 - Compressive Properties of Rigid Plastics
-
ASTM D696-08e1 - Coefficient of Linear Thermal Expansion of Plastics Between -30°C and 30°C
-
ASTM D746-14 - Brittleness Temperature of Plastics and Elastomers by Impact
