Search Results
Standard List
- Ontario Provincial Standards
- Region of Durham
- City of London
- Ontario Statutes, Regulations, etc
- ASTM International
- Canadian Standards Association
- Other Standards
- American Association of State Highway and Transportation Officials
- American Concrete Institute
- American National Standards
- American Society of Mechanical Engineers
- American Water Works Association
- Bureau de Normalisation du Québec
- Canadian Council of Independent Laboratories
- Comité Européen de Normalisation/European Committee for Standardization/Europaisches Komitee fur Normung
- Canadian General Standards Board
- Canadian Acts and Regulations
- Factory Mutual
- Goods and Services Identification Number
- International Concrete Repair Institute
- Institute of Electrical and Electronics Engineers
- International Organization for Standardization
- International Slurry Surfacing Association
- Manufacturers Standard Society
- National Council Highway Research Program
- National Master Specification
- Standards of accredited organizations or other agencies
- Strategic Highway Research Program
- Society for Protective Coatings
- Transportation Association of Canada
- Underwriters Laboratory Inc.
- UL Underwriters Laboratory Inc.
- UL 1002 Electrically Operated Valves for Use in Hazardous Locations
- UL 1004-1 Rotating Electrical Machines - General Requirements
- UL 1004-2 Impedance Protected Motors
- UL 1004-3 Thermally Protected Motors
- UL 1004-4 Electric Generators
- UL 1004-5 Fire Pump Motors
- UL 1004-6 Servo and Stepper Motors
- UL 1004-7 Electronically Protected Motors
- UL 1004-8 Inverter Duty Motors
- UL 1029 High-Intensity-Discharge Lamp Ballasts
- UL 1113 Electrically Operated Pumps for Nonflammable Liquids, Marine
- UL 1285 Pipe and Couplings, Polyvinyl Chloride (PVC), for Underground Fire Service
- UL 1433 Standard for Control Centers for Changing Message Type Electric Signs
- UL 1468 Direct Acting Pressure Reducing and Pressure Restricting Valves
- UL 1469 Backflow special check valves of 3/4-inch (19.1-mm) through 10-inch (254-mm) nominal pipe size used in piping systems supplying water for fire protection service
- UL 1478 Fire Pump Relief Valves
- UL 1478A Outline of Investigation for Pressure Relief Valves for Sprinkler Systems
- UL 157 Standard for Safety for Gaskets and Seals
- UL 1598 Luminaires
- UL 1604 Electrical Equipment for Use in Class I and II, Division 2, and Class III Hazardous (Classified) Locations
- UL 1684 (Superseded by UL 2420) Reinforced Thermosetting Resin Conduit (RTRC) and Fittings
- UL 1703 Flat-Plate Photovoltaic Modules and Panels
- UL 1739 Pilot-Operated Pressure-Control Valves for Fire-Protection Service
- UL 1778 Uninterruptable Power Systems
- UL 1897 Uplift Tests for Roof Covering Systems
- UL 193 Swing check, variable, or constant-pressure type alarm valves
- UL 194 Gasketed Joints for Ductile-Iron Pipe and Fittings for Fire Protection Service
- UL 213 Rubber Gasketed Fittings for Fire Protection Service
- UL 2202 Electric Vehicle (EV) Charging System Equipment
- UL 2231-1 Personnel Protection Systems for Electric Vehicle (EV) Supply Circuits: General Requirements
- UL 2231-2 Personnel Protection Systems for Electric Vehicle (EV) Supply Circuits: Particular Requirements for Protection Devices for Use in Charging Systems
- UL 2251 Plugs, Receptacles and Couplers for Electric Vehicles
- UL 2420 (Supersedes UL 1684) Belowground Reinforced Thermosetting Resin Conduit (RTRC) and Fittings
- UL 246 Standard for Safety for Hydrants for Fire-Protection Service
- UL 260 Standard for Dry Pipe and Deluge Valves for Fire-Protection Service
- UL 262 Gate Valves for Fire-Protection Service
- UL 263 Fire Tests of Building Construction and Materials
- UL 312 Check Valves for Fire-Protection Service
- UL 3494 Valves and Pipe Fittings
- UL 429 Electrically Operated Valves
- UL 467 Grounding and Bonding Equipment
- UL 486D Sealed Wire Connector Systems
- UL 50 Enclosures for Electrical Equipment
- UL 508 Industrial Control Equipment
- UL 651A Schedule 40 and 80 High Density Polyethylene (HDPE) Conduit
- UL 651B (Withdrawn) Continuous Length HDPE Conduit
- UL 668 Hose Valves for Fire-Protection Service
- UL 746B Polymeric Materials - Long Term Property Evaluations
- UL 746C Polymeric Materials - Use in Electrical Equipment Evaluations
- UL 790 Standard Test Methods for Fire Tests of Roof Coverings
- UL 83 Thermoplastic-Insulated Wires and Cables
- UL 8750 Light Emitting Diode (LED) Equipment for Use in Lighting Products
- UL 94 Tests for Flammability of Plastic Materials for Parts in Devices and Appliances
- Underwriters' Laboratories of Canada
Other Standards
>
Underwriters Laboratory Inc.
>
UL 1029 - High-Intensity-Discharge Lamp Ballasts
UL 1029
| Name: | High-Intensity-Discharge Lamp Ballasts |
| Code: | UL 1029 |
| Description: | |
| Type: | Specification |
| Version: | |
| External References: |
Link to Document |